| 1.
The diameter of pipe |
If pipe is nominal diameter or rectangular
type inside size, we need
measurements of width and length. |
| 2.
The standard, the thickness,and material of
the pipe |
You should present the standard of the pipe,
material (SPP, SPPS38, SPW,
and so on), the number of schedule. If the
pipes aren't standardized goods
you should present the external diameter of
the pipes(or the inside diameter)
the thickness, the material, If it is welded
type, you should present The
appearance of bevel,(Single bevel or dual
bevel, ETC,) |
| 3.
How to connect |
If it is connection of FLANGE, we need that
standard or measuremments,
Material, etc. Especially, if it is 650A and
over, you should pay attention to
standard (API, MSS, LADISH, TAYLOR) |
| 4.
Fluid |
Condition of Fluid |
| 5.
Pressure of Design |
Application of
piping condition |
| 6.
Temperature of Design |
Application of piping condition |
| 7.
Movement |
Application of piping location condition
|
| 8.
The material of BELLOWS |
According to fluid, temperature, pressure,
we will choose best one. But if
you specify specially, you should present
the temperature of the fluid and
the specificity of the material.
(We will reexamine.)
|
| 9.
Inspection |
Specification of owner |
| 10.
The Calculation Date |
We usually calculate by our standards of design.
But if it is needed to specify
specially, you should present the calculating
formula and the standard cycle
life frequency. |
| 11.
Others |
If you use it in special point or can't set
up a fixed point, you should take
counsel with us in advance. |
|
|
HOME > CALCULATION DATA > EXPANSION PART
